Volume fraction and location of voids and gaps in ultraconservative restorations by X-ray computed micro-tomography

Volume fraction (Vf) and location of internal voids and gaps in relation to material type and cavity dimensions in ultraconservative restorations were investigated in this study. Forty-eight round cavities of 1.3 mm mean diameter and 2.6 mm mean depth were made on buccal and lingual surfaces of recently extracted human teeth. These were fi lled and thermocycled with two low viscosity composites (AeliteFlo LV [AF], PermaFlo [PF]), one high viscosity composite (Aelite aesthetic enamel [AA]) and one glass-ionomer (GCFuji IX GP). X-ray microtomography, following a specifi c procedure, was applied to all cavities before and after their restoration, using SkyScan-1072 microtomographer. Vf percent (Vf%) and location of voids and gaps were recorded and analysed statistically at a = 0.05. Kruskal-Wallis nonparametric analysis of variance, post-hoc analysis, Mann-Whitney test, Spearman’s correlation analysis were used to analyze data. Cavities fi lled with AF and PF showed signifi cantly lower Vf% of voids and gaps than all other restorations (P < 0.05). Only for the cavities fi lled with AA, cavity width and depth was signifi cantly correlated with Vf% (P < 0.05). 50-75% of the fi lled cavities contained internal voids regardless of the restorative material (P > 0.05). The proportion of cavities with gaps at the bottom and side walls was lower in those fi lled with AF and PF (P < 0.05). Cavities fi lled with low viscosity composites presented the lowest amount of internal voids and gaps. Glass-ionomer and high viscosity composite restorative materials showed the highest amount of interfacial gaps. Only in the high viscosity composite restorations the amount of voids and gaps correlated with the cavity depth, width and volume.