Optimization of scheduling information in a network-based Standard IEEE802. 17 and measurement for video transmission

One of looped networks that in recent years has been much noticed is standard known as IEEE 802.17 RPR ring network or the return packet. Architecture RPR ring network protocol that transmits data between nodes connected in a double ring structure to support. RPR has two single transit buffer structure (STB) and double transit buffer (DTB), respectively. Single transit buffer architecture, just a high-priority traffic buffering (HP) and low priority (LP) passing through the ring buffer architecture serves and double, two separate buffer for high-priority and low priority traffic is considered passing.
Send information for scheduling algorithms used in network nodes RPR, queue priority (Priority-Queue), respectively. In this way, the separation of traffic based on priority and high priority traffic has absolute priority over lower priority traffic so that always the highest priority to transit buffer appropriated therefore of high priority traffic such as video packet, the nodes access to congested suffered numerous delays and instability vibration are ring (Jitter).
In this thesis addition to scheduling priority queue, plans, schedules DRR and DRR to increase the quality of service to traffic with high priority on congested node in a network with a ring structure with 10 nodes software Opnet simulation and the performance timing of passing information about at least two network nodes in the hub scenario (hUB) in which all the nodes transmit information to a node with video traffic conditions, congestion were examined happened and qualitative results were compared to that, the display shows the relative improvements in reducing delays and instability shaking changes in the timing of DRR and DRR compared to the recommended standard.