جستجوی مقالات مرتبط با کلیدواژه « شکل دهی مجدد لوله » در نشریات گروه « مکانیک »

Because of their wide application in industries requiring high pressure and temperature, manufacturing square and rectangular pipes have attracted more attention than ever before. There are various methods such as extrusion, tensile and stress for manufacturing square pipes. Another method on which studies have focused in recent years is the re-forming of round pipes in order to turn them into square or rectangular ones. The methods suggested in these researches are all applicable for the manufacture of square pipes without the possibility of manufacturing rectangular pipes. The method introduced in this paper consists of filling the pipe with bismuth and rolling it in three successive stages. In this research, first, the intended process is simulated in Abaqus software, and then a real sample is manufactured by an experimental test. The manufactured sample is checked with regard to its dimensions and is compared with the results obtained from the simulation. The results of the study show that the method of filling the pipe with bismuth and moving it through three rollers is an appropriate method for the manufacture of thin-walled pipes with rectangular cross-section.

Predicting the status of contact between the pipe and the roll through deformation is considered as one of the problems of reshaping process in non-circular pipe production. In the present study, the elastic-plastic analysis is investigated assuming plane strain condition for reshaping process. One of the problems of the mentioned process is the separation of pipe from roll in some zones. The proposed model has the capability of predicting the separation of the pipe from roll, which results in better prediction of the defect. To verify the reliability of the present contact model, the result of the analysis was compared to those of experimental ones and showed good agreements.