جستجوی مقالات مرتبط با کلیدواژه « فرزی کاری » در نشریات گروه « مکانیک »

Advances in many engineering fields depend on materials with appropriate properties. The use of metal-matrix composites is rapidly growing as a suitable alternative to conventional materials due to their strength-to-weight ratio, resistance to wear and creep, etc. Machining of metal-based composites is a difficult task due to the presence of very abrasive reinforcing particles in its based metal. Therefore, it is necessary to investigate the factors affecting these materials. In this research, a methodical study has been conducted to investigate the effect of the parameters of spindle  speed, feed rate, depth of cut and the percentage of reinforcing particles on the behavior of cutting force and tool wear using experimental design methods, modeling and statistical sensitivity analysis methods. . Detailed analysis of behaviors has been done by providing statistical regression equations and optimization by Deringer's method and E-Fast-Sensitivity Analysis. According to the obtained results, the cutting depth had the greatest effect on the machining force. Also, cutting speed with 77%, advance rate with 9% percent and cutting depth and weight percent of reinforcing particles with 7% percent are other parameters affecting tool wear in the milling process of this composite.

Today, various military, aerospace, automotive, etc. industries need materials with a high strength-to-weight ratio. The use of metal-based composite materials, especially aluminum-based composites, has increased greatly. Machining is needed to achieve high dimensional accuracy in products made with aluminum-based composites. Due to the presence of reinforcing material such as silicon carbide, machining of this type of material is difficult. Therefore, it is important to study the parameters affecting the machining of aluminum-based composites. In this study, the effect of spindle speed, feed rate, depth of cut and percentage of reinforcing particles were discussed using experimental and statistical test methods. The responses of surface roughness and material removal rate were investigated. The behavior of the input parameters on the responses of the process has been carefully investigated quantitatively and qualitatively. Answers have also been optimized. According to the obtained results, the spindle speed has the greatest effect on the surface roughness. Also, feed rate 33%, spindle speed 28%, depth of cut 26% and the percentage of reinforcing particles 13% have an effect on the chipping rate.