جستجوی مقالات مرتبط با کلیدواژه "cutting force fluctuation" در نشریات گروه "مکانیک"

Hot machining is a type of cutting operation that an external heat source is used to pre-heat and consequently reduce the yield strength of the workpiece material. In this study, the conventional and hot turning of AISI630 hardened stainless steel, which is widely used in energy equipment, aerospace, and petrochemical industries, have been evaluated in both numerical and experimental methods. Simulation of the turning process is carried out by finite elements method (FEM) using AdvantEdge software. To predict chip morphology and cutting forces, the 2D and 3D FEM analyses have been used, respectively. The numerical analysis showed that hot turning in 300°C causes a reduction of 28% in cutting forces and consequently decreases stressed on the cutting tool. It is found that the main factor affecting the fluctuations of the cutting forces in turning of hardened AISI630 is the saw-tooth formation phenomenon (chip segmentation) as well as the shear band generation due to thermal softening of the workpiece material. Furthermore, the relation between cutting force fluctuation and the machined surface roughness has been investigated applying numerical analysis and experimental data. The results of roughness measurement revealed that hot turning in 300°C reduces the machined surface roughness up to 23%. In addition, it has been observed that hot turning technique decreases side flow and surface damages in comparison to conventional turning.